Description

Poly Bundlers | Preferred Pack PP-6030Z/PP-6040M Inline Fully Automatic

Inline Fully Automatic

Model PP-6030Z Automatic In-Line Poly Bundler/Sleeve Wrapper with Model PP-6040M Shrink Tunnel. This system is a Fully Automatic In-Line machine with a seal size of 27.5” Wide x 16” H tunnel opening. This system uses 2 single wound rolls of polyethylene film, one located on top of the machine and one located at the bottom of the machine, and these two sheets are sealed together at the center to make one sheet of film that the package will travel through. As the product travels down the infeed conveyor a photo eye is activated by the product and the film is automatically advanced past the seal bar, once the product has passed through the seal area, the seal bar is activated and comes down to seal the film around the product. At this point the package is sealed in a poly film with the ends open, now the package is picked up by the tunnel conveyor belt and automatically transferred into the shrink tunnel where the film will be heated up and will then shrink tightly around the package somewhat closing or reducing the size of the open ends, if enough film is used you can sometimes completely enclose the package ends with compression rollers. Production speeds of 5 to 15+ PPM can be obtained depending on package length, film thickness, etc.

Standard Features of Sealer Include:

• 27.5” Wide Hot Knife Seal Bar with Safety Switches.
• Maximum width film roll is 25”
• 30” Power Belted infeed conveyor with photo eye activation to transport product into and through the sealing area
• 20” powered discharge conveyor to power the product into the shrink tunnel
• Independent Seal timer
• VFD Drive for conveyor speed control
• Easy to use front control panel with digital temperature controls
• Dual film rack (one film roll on top and one on bottom) with independent motor drives
• Film threading diagrams
• Pneumatic product hold down to stabilize product on the discharge conveyor.
• Machine speeds of 5 to 15 PPM depending on product size and film gauge used.
• Digital seal bar temp control 0-400 Degrees F
• Working height of 33.5” (+-/ 2”)
• AC Variable speed motor inverters with PLC

Standard Features of Tunnel Include:

• Tunnel size of 71” L x 24” W x 15”H
• Heavy duty high RPM, high air velocity blower motor.
• Heavy duty dead roller conveyor used to transport product through tunnel
• Cooling fans on the discharge end of the tunnel.
• Air velocity from all 4 sides for better shrink results
• Manufactured under GMP standards to exceed OHSA safety standards
• Will run any commercial grade polyethylene film
• Emergency stop switch on front control
• Side safety door interlock switches-if door is opened machine will automatically shut off
• Air regulator with water trap.
• Max Package size: Unlimited length x 20” W x 12” H

SPECIFICATIONS

• Electrical Power:220 Volt 3 PH 97 Amp
• Seal Size:27.5 Inch (699 mm)
• Max Roll Width:25 Inch (635 mm)
• Max Pkg Length :Unlimited
• Speed: Up to 15 Packages/Min
• Air Requirement: 5 CFM 80 PSI
• Shipping Weight: 1100 lbs.
• Phase: 1
• Power (W): 37 KW
• Tunnel Size (L x W x H):71 x 24 x 16 Inch (1803 x 610 x 406 mm)




DEMO VIDEO









If you have any questions or concerns, contact a customer service representative today.
Phone: 877.336.6877 Visit: www.officeequipmentmachineshop.com


COVID Supply Chain Warning Due to global challenges including COVID and Climate Change affecting all businesses, prices are subject to change because of supply chain disruptions, shipping delays, labor shortages, material shortages, and inflationary pressures. If you place an order, and there is an increase in a price from that shown, we will alert you before processing the order.